Caution Messages - Sony VPL-CX70 Operating Instructions Manual

Message
Frequency is out of range!
Please check Input-A
Signal Sel.
Please replace the Lamp.
Please clean the filter.

Caution Messages

Use the list below to check the meaning of the messages displayed on the screen.
Message
Not applicable!
The panel keys are locked! "Panel Key Lock" on the INSTALL SETTING menu is set to "On."
Meaning and Remedy
• This input signal cannot be projected as the frequency is out of the
acceptable range of the projector.
c Input a signal that is within the range of the frequency.
• The resolution setting of the output signal of the computer is too
high.
c Set the output setting to XGA (see page 13).
You have input an RGB signal from the computer when "Input-A
Signal Sel." on the SET SETTING menu is set to "Component."
c Set "Input-A Signal Sel." correctly (see page 29).
• It is time to replace the lamp.
c Replace the lamp.
• When this message appears even after replacing the lamp, the task
has not been completed.
c Perform the operation of steps 8 and 9 on page 37.
c To erase a message, press any key on the control panel of the
projector or on the remote commander.
It is time to clean the filter.
c Clean the filter (see page 38).
Meaning and Remedy
You have pressed the wrong key.
c Press the appropriate key.
c All the keys on the control panel of the projector are locked.
Operate the projector with the keys on the Remote Commander
(see page 30).
43
Troubleshooting