Messages List - Sony VPL-CX70 Operating Instructions Manual

Indicators
Symptom
The LAMP/COVER
indicator flashes.
The LAMP/COVER
indicator lights up.
The TEMP/FAN indicator
flashes.
The TEMP/FAN indicator
lights up.
Both the LAMP/COVER
and TEMP/FAN indicators
light up.

Messages List

Warning Messages
Use the list below to check the meaning of the messages displayed on the screen.
Message
High temp.!
Probably use in high
altitude. Switch to high
altitude mode on? Yes V
No v
High temp.! Lamp off in 1
min.
42
Troubleshooting
Cause and Remedy
• The lamp cover or the air filter cover is detached.
c Attach the cover securely (see pages 37 and 38).
• The lens protector did not open due to a problem.
c In case of emergency, slide the lens protector open by hand, and
then press the ?/1 key. If this problem occurs again, consult
with qualified Sony personnel.
• The electrical system may have broken down.
c Consult with qualified Sony personnel.
• The lamp has reached the end of its life.
c Replace the lamp (see page 36).
• The lamp has reached a high temperature.
c Wait for 60 seconds to cool the lamp and then turn on the power
again.
• If the LAMP/COVER indicator still lights even after you have
replaced the lamp, the electrical system may break down.
c Consult with qualified Sony personnel.
The fan is broken.
c Consult with qualified Sony personnel.
• The internal temperature is unusually high.
c Check to see that nothing is blocking the ventilation holes.
• The projector is being used at a high altitude.
c Ensure that "High Altitude Mode" on the INSTALL SETTING
menu is set to "On."
The electrical system has broken down.
c Consult with qualified Sony personnel.
Meaning and Remedy
Internal temperature is too high.
c When using the projector at an altitude of 1,500 m or higher, set
"High Altitude Mode" on the INSTALL SETTING menu to "On"
(see page 33).
c If this message appears on the screen when using the projector at
normal altitudes, check to see if anything is blocking the
ventilation holes (exhaust).
The internal temperature is too high.
c Turn off the power.
c Check to see that nothing is blocking the ventilation holes.