Miele DAD 4840 Operating And Installation Instructions page 45

a Exhaust air with flat ducting and
DMK 150-1 wall box
b Recirculation with flat ducting and
DUU 600 recirculation box
c Plug&Play operation with DUP 150
conversion kit
During Plug&Play operation, ensure
sufficient ventilation of the plinth
area, e.g. through gaps in the plinth
panel.
The cross-section of the openings
must be at least 425 cm² in total.
If the floor meets the ground or is
exposed to outside air, the heat
transfer coefficient of the floor must
not exceed 0.5 /(m² K).
The electronic module for vapour
extraction must be switched to
Plug&Play operation, see "Before
using for the first time" – "Setting up
Plug&Play".
Installation
45