Setup Utility-Integrated Peripherals - HP t505 Troubleshooting Manual

Table 3-4
1st Boot Device
2nd Boot Device
3rd Boot Device
Boot Up Numlock
Status
POST Delay (secs)
F12 Boot
Setup Utility—Integrated Peripherals
Table 3-5 Setup Utility—Integrated Peripherals
Option
Integrated Audio
Network Controller
USB Controller
Advanced USB
Options
USB Keyboard
Support
USB Mouse Support
Serial Port 1
Serial Port 2
Serial Port 3
Serial Port 4
Parallel Port
Parallel Mode
ECP Mode Use DMA
24 Chapter 3 BIOS Settings, (F10) Utility
Setup Utility—Advanced BIOS Features (continued)
Select Boot Device Priority. Default is USB.
Select Boot Device Priority. Default is ATA Flash.
Select Boot Device Priority. Default is Network.
Select power on state for Numlock. Default is OFF.
Set a delay that is added to POST to allow more time to press
Default is None.
Enable/Disable F12 network boot. Default is Enabled.
Description
Enable or Disable Onboard AC97 Audio controller. Default is Enabled.
Enable or Disable Onboard LAN device. Default is enabled.
Enable or Disable USB controller. Default is enabled.
Enable or Disable USB external ports. Default is enabled.
Allows use of USB keyboard under DOS. Default is enabled.
Allows use of USB Mouse under DOS. Default is disabled.
Select serial port base IO port address and IRQ. Default is 3F8/IRQ4
Select serial port base IO port address and IRQ. Default is 2F8/IRQ3
Select serial port base IO port address and IRQ. Default is 3E8/IRQ5
Select serial port base IO port address and IRQ. Default is 2E8/IRQ10
Select parallel port base IO port address and IRQ. Default is 378/IRQ7.
Select parallel port transfer mode of Standard, EPP, ECP, or ECP/EPP. Default is ECP/EPP.
Select DMA channel of 1 or 3 if parallel is operated in ECP mode. Default is 3.
F10 to enter the Setup Utility.