Installing Thin Client Options
Various options can be installed on the thin client:
●
Removing and Replacing the Battery on page 10
●
External Drives on page 11
Removing and Replacing the Battery
Before beginning the replacement process, review
on page 7
WARNING!
power cord is disconnected from the electrical outlet.
To remove and replace the battery:
1.
Locate the battery on the system board.
2.
To release the battery from its holder, squeeze the metal clamp that extends above one edge of
the battery. When the battery pops up, lift it out (1).
Figure 2-2
3.
To insert the new battery, slide one edge of the replacement battery under the holder's lip with
the positive side up (2). Push the other edge down until the clamp snaps over the other edge of
the battery.
HP encourages customers to recycle used electronic hardware, HP original print cartridges, and
rechargeable batteries. For more information about recycling programs, go to
recycle.
10
Chapter 2 Hardware Changes
for procedures you should follow before and after installing or replacing hardware.
Before removing the side access panel, ensure that the thin client is turned off and the
Removing and replacing the internal battery
Batteries, battery packs, and accumulators should not be disposed of together with the general
household waste. In order to forward them to recycling or proper disposal, please use the public
collection system or return them to HP, an authorized HP partner, or their agents.
General Hardware Installation Sequence
http://www.hp.com/go/