Setting Bcim Switches And Jumpers - Huawei Airbridge cBTS3612 Installation Manual

Installation Manual
Airbridge cBTS3612 CDMA Base Station
enclosure frame at the cabinet side, and finally install or disassemble the six captive
screws on the side door; thus, that is the whole process.
II. Installing or disassembling rear doors
For the installation or disassembly of the rear door, align rear door with positioning
pin of the lower enclosure frame at the back of the cabinet, and install or
disassemble the six captive screws on the rear door. Thus that is the whole process.
III. Installing or disassembling left-front door and right-front door
During the installation for right-front door, align the door with the positioning pin at
the right-front of the cabinet, pull the pin at the upper part of the right-front door and
align it with the pin hole, thus ending the installation. The process for disassembling
the right -front door is exactly reversed.
The process for installing or disassembling left -front door is similar to that for
installing or disassembling right-front door.

4.4 Setting BCIM Switches and Jumpers

The DIP switches of the BCIM and jumpers are shown in Figure 4-2.
ON
ON
ON
ON
Figure 4-2 BCIM DIP switches and jumpers
Please see Table 4-1 for details of BCIM DIP switch and jumper.
S5 S4
ON
1 2 3 4 1 2 3 4
S3 S2
ON
1 2 3 4 1 2 3 4
S9 S8
ON
1 2 3 4 1 2 3 4
S7 S6
ON
1 2 3 4 1 2 3 4
4 Installation of Cabinet Modules and Parts
4-4
Hardware Installation