Huawei NetCol5000-A050 User Manual page 154

NetCol5000-A050 In-row Air Cooled Smart Cooling
Product
User Manual
Paramete
r
Enable
teamwork
CAN
resistor
Teamwork
function
Networkin
g mode
Number
of systems
in this
group
Issue 08 (2021-09-17)
Description
Specifies the build-out
resistor status of each
smart cooling product in
teamwork networking. Set
the parameter if CAN
network is used.
Specifies whether to enable
the teamwork function. If
no, the unit operates
independently. If yes, the
unit operates in a team
with other units.
Networking mode for the
teamwork. The networking
mode set on the screen
must be consistent with the
actual networking mode.
Otherwise, the teamwork
control function will be
unavailable. If the
networking mode changes,
select the corresponding
networking mode on the
screen.
Specifies the number of
smart cooling products in a
group. The value is an
integer ranging from 1 to
32.
Copyright © Huawei Technologies Co., Ltd.
6 Power-On Commissioning
Setting Rule
● Set this parameter
to No for non-
teamwork
scenarios.
● For teamwork
scenarios, set this
parameter to Yes
for the first and
last smart cooling
products in a
teamwork group,
and set it to No for
other smart cooling
products.
Set this parameter
based on the onsite
device heat
distribution.
Networked over CAN
or MAC_CAN. CAN
network indicates
teamwork control
over a CAN bus.
MAC_CAN network
indicates teamwork
control over an FE
port.
If the device is
connected to the
smart ETH gateway or
ECC800-Pro, set the
parameter to
MAC_CAN network.
In other scenarios, set
the parameter to CAN
network.
Enter the total
number of smart
cooling products in
the group.
Default
Value
No
Disable
CAN
network
3
144