Figure 14 Ipmb Connector; Figure 15 Power Using Reset/Power Wires - Acer ARMC_3P User Manual

12
Connecting to ATX Control Signals
In case your system provides separated pins for reset and power on/off, perform
the following steps while referring to Figure 7 ARMC/3P Internal Connectors.
1. Find the cable connecting the front panel reset button and the motherboard.
2. Disconnect this cable from the motherboard and connect it to RST2 of the
ARMC/3P. Refer to Figure 9 for pin assignment.
3. Take the reset cable provided with the ARMC/3P and connect one end to the
motherboard's reset connector (from where you just disconnected the cable to
the front panel), and the other end to RST1 of the RST/PWR connector of the
ARMC/3P.
4. Find the cable connecting the front panel power button and the motherboard.
5. Disconnect this cable from the motherboard and connect it to PWR2. For pin
assignment details, refer to Figure 9.
6. Take the power cable provided with the ARMC/3P and connect one end to the
motherboard's power connector (from where you just discon- nected the cable
to the front panel), and the other end to PWR1 of the RST/PWR connector of
the ARMC/3P.
7. Check the cabling: there are four cables connected to the RST/PWR connector,
finally.

Figure 14 IPMB Connector

Figure 15 Power using Reset/Power Wires

P U G
RODUCT SER UIDE