Software; Ups Software; Touch Screen Software; Fig. 9-1: Updd Setup Programs For The Touch Screen - Bosch REXROTH VSB 40.1 Project Planning Manual

VSB 40.1
9

Software

9.1

UPS Software

9.2

Touch Screen Software

DOK-SUPPL*-VSB*40.1***-PR02-EN-P
The software required for the optionally available UPS (see chapter 8.3
"Connection of the Uninterruptible Power Supply" on page 8-2 and section
chapter "Uninterruptible Power Supply" on page 11-2) is stored on the
hard disk of the VSB 40.1. Before being able to use this software, you
have to install it. Install this software using the installation softaware
BRCVInstall saved on the desktop.
For certain VDP-type displays a touch screen is integrated, that allows the
operation via the touch-sensitive surface of the display.
The device-internal serial interface COM2 is used for the communication
between the touch screen controller and the PC.
You have to install the required driver software by means of the
installation software BRCVInstall archived on the desktop.
After the installation settings and changes in the application "Pointer
Devices" in the Windows Control Panel are possible. You can reach this
setup program via "Start -> Programs -> UPDD -> Settings.
Fig. 9-1: UPDD setup programs for the touch screen
9-1
Software
UPDD_start.bmp