Miele G 7881 Operating Instructions Manual page 49

Unsatisfactory cleaning results
Unsatisfactory cleaning results may
occur as drying spots, or as spots that
look like corrosion. Presumably,
corrosion spots are often bio-debris.
They have the shape of drying spots,
blurry edges and a rust color.
Bio-debris may also appear on
surfaces that were not contaminated
before processing. To remedy this
problem:
^ Run the machine within six hours of
loading, even if it is partially loaded.
^ Check the dosage of the detergent
and adjust. Too little or too much
detergent may deteriorate cleaning
results.
^ Rearrange the load to be cleaned so
that the spray arms can rotate freely.
^ Check if anything obstructs the
powdered detergent dispenser flap.
Correcting minor faults
The water in the wash cabinet is not
heated or the program sequence
lasts too long (fault code "F01-F03,
F18, F19" appears in the display)
The machine has a resettable
temperature limiter which will shut off
the heating elements in the case of
overheating. This could be caused if
large articles cover the heating
elements or if the filters in the wash
cabinet are blocked.
^ Remove the cause of overheating.
^ Remove the service panel.
^ Press the blue "Reset" button on the
temperature limiter.
If this switch trips repeatedly, contact
the Miele Technical Service
Department.
45