Basic dismantle/assembly
7.4 Wear guard LiR / LiRX
Loosen the screws (A 6x) and (B 4x) and lift off the
right half of the wear guard.
See figure 4
NB! Secure the left half of the wear guard to
the shaft with a cable tie or similar to hold the
cables in place and avoid damage.
See fig. 5.
Assemble in the reverse order.
NB! Check that the cables are not pinched
behind the shaft.
Refer to "Assembling the control cable LiR".
Tightening torque 2 ~ 3 Nm.
30 –
English
B
Fig 4
Fig 5
A
A
B