Sony XBA-1iP Operating Instructions

Stereo Headset
Operating Instructions
Manual de instrucciones
4-408-899-11(1)
©2011 Sony Corporation
Printed in Thailand
XBA-1iP
English Stereo headset
Using the Center button
 Newly developed Balanced Armature driver
Plays/pauses a track of the connected iPod product unit
Newly developed micro-size driver unit (full-range)
with a single press. Skips to the next track with a double
reproduces smooth and clear vocal sound.
press. Skips to the previous track with a triple press.
 Newly developed Double Layered Housing
Starts the "VoiceOver*" feature with a long press (if
Liquid Crystal Polymer inner housing and special
available).
Press once to answer the call. Press again to end. Hold ABS outer housing reproduce clear, distortion-free
mid-high range.
down for about two seconds to reject an incoming call.
When you let go, two low beeps confirm the call was  Noise-blocking design
Noise-blocking design attenuates ambient noise and
rejected.
sound leakage.
* Availability of the "VoiceOver" feature depends on
 Super-small body
iPod and its software version.
Balanced Armature driver unit allows for a super
Note
small body, and ultimate wearing comfort.
Be careful not to unintentionally press any buttons
Specifications
when you carry your iPod with this unit connected.
Headphones
Features
Type: Closed, Balanced Armature
 Earbuds with remote controller for iPod/
Driver unit: Balanced Armature
iPhone/iPad
Power handling capacity: 100 mW (IEC*)
Easy-to-use remote control (only for iPod, iPhone
Impedance: 24 Ω at 1 kHz
and iPad)
Sensitivity: 108 dB**
How to use
Volume +*
Center button
Volume –
* There is a tactile dot beside Volume +.
Frequency response: 5 Hz – 25,000 Hz
You are cautioned that any changes or modifications
Cord: 1.2 m (47 1 / in) (Y-type)
not expressly approved in this manual could void your
4
Plug: Four-conductor gold-plated L-shaped stereo
authority to operate this equipment.
mini plug for iPod with remote function
About noise isolation earbuds
Mass: Approx. 3 g (0.11 oz) (without cord)
Supplied noise isolation earbuds provide a snug fit for
Microphone
effective attenuation of ambient noise.
Open circuit voltage level: – 42 dB (0 dB=1 V/Pa)
Notes
Supplied accessories
Hybrid silicone rubber earbuds: SS (red) (2), S (orange)  Prolonged use of snugly fitting earbuds may strain
your ears. If you experience discomfort, discontinue
(2), M (green) (attached to the unit at the factory) (2),
L (light blue) (2) / Noise isolation earbuds: S (orange) use.
 The pressure-relieving urethane cushion is extremely
(2), M (green) (2), L (light blue) (2) / Cord adjuster
(winds cord up to 50 cm (19 / in)) (1) / Clip (1) / soft. If it breaks or detaches from the earbuds, it will
3
4
not take its correct position and the earbuds will lose
Carrying pouch (1)
their noise isolation function.
* IEC = International Electrotechnical Commission
** 150 mV input  The urethane cushion may deteriorate over time. If
the pressure-relieving power is lost and the urethane
Design and specifications are subject to change without
notice. cushion hardens, the earbuds may lose their noise
isolation function.
Optional replacement earbuds can be ordered from
 Do not wash the earbuds. Keep them dry, otherwise
your nearest authorized Sony retailer or www.sony.
they may deteriorate quickly.
com.
Clip
Microphone
About hybrid silicone rubber earbuds
Keep earbuds clean. To clean the earbuds, wash them
with a mild detergent solution.
Removing the headphones
After use, remove the headphones slowly.
 Do not leave the stereo headphones in a location
Note
subject to direct sunlight, heat or moisture.
Headphones are designed to fit closely in your ears. If the
Note on static electricity
headphones are pressed hard while in use or taken off too
Static electricity accumulated in the body may cause
quickly, they may cause injury.
mild tingling in your ears.
Wearing headphones may produce a diaphragm click
To minimise the effect, wear clothes made from natural
sound. This is not a malfunction.
materials.
Precautions
High volume may affect your hearing.
For traffic safety, do not use while
driving or cycling.
Earbuds
Hybrid silicone rubber earbuds
SS S M L
Install the earbuds firmly. If an earbud Compatible iPod/iPhone models
accidentally detaches and is left in
You can use the unit with only the following models
your ear, it may cause injury. supporting remote control. Update your iPod, iPhone
or iPad to the latest software before use. In the
Operating Instructions, iPod, iPhone and iPad are
collectively described as "iPod" except in special cases.
 iPod touch 4th generation
 iPod touch 3rd generation
 iPod touch 2nd generation
 iPod nano 6th generation
 iPod nano 5th generation (video camera)
 iPod nano 4th generation (video)
 iPod classic 120GB 160GB (2009)
 iPod shuffle 4th generation
 iPod shuffle 3rd generation
 iPhone 4
 iPhone 3GS
 iPad 2
 iPad
Noise isolation earbuds
Pressure-relieving
urethane cushion
S M L
On copyright
® ® ® ®
iPhone , iPod , iPod classic , iPod nano , iPod
® ®
shuffle , and iPod touch are trademarks of Apple
®
Inc., registered in the U.S. and other countries. iPad is
a trademark of Apple Inc.
"Made for iPod, " "Made for iPhone, " and "Made for
iPad" mean that an electronic accessory has been
designed to connect specifically to iPod, iPhone, or
iPad, respectively, and has been certified by the
developer to meet Apple performance standards. Apple
is not responsible for the operation of this device or its
compliance with safety and regulatory standards.