D-Link Air DWL-900AP User Manual page 39

SNMP Utility Menus (continued)
Shared Key: With this setting only stations using a shared key
encryption identified by the Access Point are allowed to associate with it.
Both: With this setting stations can communicate with or without data
encryption.
Key 1 - Key 4
64 bit: Active Key ID 1 to 4. These values can only be edited if a WEP type
is selected to 64-bits.
128 bit: Active Key ID 1 to 4. These values can only be edited if a WEP type
is selected to 128-bits.
These four fields can be used to manually enter the encryption keys. This
may be necessary if you wish this node to match keys in a different vendor's
product. These fields also display the keys when they are generated using a
Pass-phrase.
NOTE: 64 bit WEP is the same as 40 bit WEP! The lower level of WEP
encryption uses a 40 bit (10 character) "secret key" (set by the user), and a
24 bit "Initialization Vector" (not under user control). The panel allows the
entry of four keys for 64-bit encryption and one set for 128-bit key encryption.
Each key must consist of hex digits, which means that only digits 0-9 and
letters A-F are valid entries. The Configuration Utility will not apply keys
that are not entered correctly.
About
The About
information about the SNMP Manager.
This screen also displays the software
version of SNMP Manager and the
firmware version of the Wireless Access
Point.
tab displays general