Add Read-Only Access To An Interface; Enable Snmp Access To An Interface - D-Link DFL-1100 User Manual

Add Read-only access to an interface

Note that if you have read-only access enabled on an interface, all users will get read-only
access, even if they are administrators.
Follow these steps to add read-only access to an interface.
Step 1. Click on the interface.
Step 2. Enable the Read-only checkbox.
Step 3. Specify which networks are allowed to access the interface, for example
192.168.1.0/24 for a whole network, or 172.16.0.1 – 172.16.0.10 for a range.
Step 4. Specify the protocol used to access the DFL-1100 from the dropdown menu, both
HTTP and HTTPS (Secure HTTP), or only HTTPS.
Click the Apply button to apply the setting, or click Cancel to discard the changes.
Example:

Enable SNMP access to an interface

Follow these steps to add read-only SNMP access to an interface.
Step 1. Click on the interface to which you would like to add it.
Step 2. Enable the Read-only checkbox.
Step 3. Specify what network addresses are allowed to receive SNMP Traps, for example
192.168.1.0/24 for a whole network or 172.16.0.1 – 172.16.0.10 for a range.
Step 4. Specify the community string used to authenticate against the DFL-1100.
Click the Apply button to apply the setting, or click Cancel to discard the changes.