Buzzer Volume; Keypad Tone; Conductivity - Miele TMV 840 WP Operating Instructions Manual

–
Light
Clean out airways
is only a small build-up of fluff.

Buzzer volume

The buzzer sounds to indicate the end
of the programme. It can be set to be
louder or quieter or switched off.
The continuous tone which sounds
when there is a fault is independent of
the buzzer.
The setting selected is shown in a bar
chart.
Factory default: a medium setting.
–
     
Switched off
–
      
Quieter
–
      
Louder
You will hear the buzzer change as the
setting is selected.
 Confirm with the

Keypad tone

When this setting is activated, a tone
will sound each time a sensor is
touched.
Options
–
On
– (factory default)
Off
appears when there
sensor.
OK

Conductivity


The option should only be
Low
selected if the residual moisture
reading in your laundry is incorrect
due to extremely soft water.
Options
– (factory default)
Normal
–
Low
Condition for low conductivity setting
This programmable function should
only be set if the water used for
washing the laundry is extremely soft
with a conductivity reading (electrical
conductivity) less than 150 μS/cm.
Contact your local water authority for
the conductivity level of your mains
water supply.

Only activate the Low option if
the above condition is present.
Otherwise drying results will be
unsatisfactory.
Settings menu
93