Miele TMV 840 WP Operating Instructions Manual page 64

Problem solving guide
Problem

Information
Clean out airways
lights up at the end of a
programme

Clean out airways
Clean the fluff filter and
check the airways
lights up after a
programme is cancelled

Empty the container
Empty the container or
check the drain hose
lights up after a
programme is cancelled

Information
Fill condensate reservoir

Information
Please open and close the
door
Extra cooling
64
Possible cause and remedy
There is a build-up of fluff in the airways.
 Clean the fluff filters.
 Clean the plinth filter.
See "Cleaning and care".
To switch off the message:
 Select OK.
An excessive amount of fluff has built up.
 Clean the fluff filters.
 Clean the plinth filter.
 Clean the airways: The area underneath the plinth
filter and the heat exchanger.
 To switch off the messages: Switch the dryer off
and back on again.
The condensed water container is full or there is a
kink in the drain hose.
 Empty out the condensed water container.
 Check the drain hose.
To switch off the message:
 Open and close the door while the dryer is
switched on or switch the dryer off and back on
again.
This is to remind you that water is taken from the
condensed water container when the Steam
smoothing programme is being used. The condensed
water container must be filled with water to at least
the –min– marker.
 Confirm with OK.
 Open and close the door to enable drying.
This it to remind you to load the laundry when the
Steam smoothing programme is selected.
 Load the laundry in the drum.
The programme has finished but the laundry has not
yet cooled down.
 Either remove the laundry and spread it out to cool
down or leave it in the tumble dryer to cool down
during the cooling phase.