Table of Contents
Advertisement
Remove four small screws from the rear side of the display, than separate the
4
stand from the PDP.
Remove four large screws from the rear side of the display.
5
Insert the bolts and insulation holders into the four screw-holes as shown in the
6
following figure:
ΠBolt
´ Insulation holder
16
Hang the protruding plastic part on the rear of the PDP in the groove on the
7
top of the wall attachment panel. Then, slide down the PDP. (Do not slide
down the PDP with too much force. The protruding plastic part might be taken
off.)
´
Separating the Display from the Wall Attachment Panel
Œ
Œ
´
17
Advertisement
Table of Contents
