Table of Contents
Advertisement
Memorizing the Channels
Your PDP can memorize and store all of the available channels for both "off-air" (antenna)
and cable channels. After the available channels are memorized, use the CH
buttons to scan through the channels. This eliminates the need to change channels by entering
the channel digits. There are three steps for memorizing channels: selecting a broadcast
source, memorizing the channels (automatic) and adding and deleting channels (manual).
Selecting the Video Signal-source
Before your television can begin memorizing the available channels, you must specify the type of
signal source that is connected to the PDP (i.e., an antenna or a cable system).
Press the Menu button. Move the joystick up or
1
down to select "Channel", then press the joystick
to enter.
Move the joystick left or right to select "Ant",
2
"STD", "HRC" or "IRC".
• If you are connected to an antenna, leave "Ant"
displayed. If you connected cable, Move the
joystick left or right to the display the type of cable
system: "STD", "HRC", or "IRC".
(If you are not sure which type of cable system you
have, contact your cable company).
Press the Menu button to exit.
3
Note
• STD, HRC and IRC identify various types of cable TV systems. Contact your local cable company
to identify the type of cable system that exists in your particular area.
At this point the signal source has been selected. Proceed to "Storing Channels in Memory"
(next page).
32
and CH
Channel
Ant/ CATV
Ant
Auto Program
Fine Tune
0
LNA
Off
Move
Select
Exit
Channel
Ant/ CATV
STD
Auto Program
Fine Tune
0
LNA
Off
Move
Select
Exit
Storing Channels in Memory (Automatic Method)
First, select the correct signal source (Ant, STD, HRC,
1
IRC). See steps on previous page.
Press the Menu button. Move the joystick up or down to
select the "Channel", then press the joystick to enter.
!
Quick way to access the Automatic Channel Setting :
Just press the "Auto Program"button on the remote control.
Move the joystick up or down to select "Auto Program",
2
then press the joystick to enter.
The PDP will begin memorizing all of the available
3
channels.
After all the available channels are stored, the
Auto program menu reappears. Move the joystick right
to exit.
Note
• The PDP automatically cycles through all of the available channels and stores them in memory.
This takes about one to two minutes.
Channel
Ant/ CATV
Ant
Auto Program
Fine Tune
0
LNA
Off
Move
Select
Exit
Channel
Ant / CATV
Ant
Auto Program
Fine Tune
0
LNA
Off
Move
Enter
Exit
Ant 50
Auto Program
: Stop
33
Advertisement
Table of Contents
