Panasonic WJ-HDE300 Conversion Manual page 10

Digital disk recorder extension unit

Hide thumbs Also See for WJ-HDE300:

WJ-HDE300 S-ATA conversion guide

(28) Fix two HDD fan assemblies with one screw each, and

connect each HDD fan connector to the main board.

(29) Attach the cord clamp to the HDD3, 4 fan assembly and

secure the HDD3, 4 S-ATA cables, as shown right.

(30) Install new HDDs on the HDD mounting brackets with four screws each. Refer to the "Operating Instructions" for detail.

Notes:

When disconnecting the ATA cables, pull the pull-ring slowly and straightforward.

S-ATA HDD's do not require jumper configuration.

Install the HDD, board side facing down and the connectors pointing toward the front.

Take care not to deform the dampers when installing the HDD.

(31) Install the HDD unit in the reverse order of the removal.

Panasonic System Solutions

Clamp

Maintenance guide

HDD Fan Ass'y

Main board

HDD Fan Connector

HDE300_SATAConversionGuide_B