Huawei Eudemon8000E Series Manual page 94

HUAWEI Eudemon8000E Firewall
Hardware Description
13. RUN indicator 14. Console
Table 4-11
Table 4-11 Buttons and indicators on the MPUD panel
Indicator/
Button
OFL button
OFL indicator
(red)
RUN indicator
(green)
ALM indicator
(red)
ACT active/
standby indicator
(green)
Reset button
CF ACT indicator
(green)
LINK indicator
(green) (on the
Ethernet
interface)
ACT indicator
(amber) (on
Ethernet
interfaces)
Table 4-12
Issue 01 (2012-11-07)
describes the buttons and indicators on the MPUD panel.
Description
To remove a board, you must press and hold the button for six seconds
until the OFL indicator turns on.
Note:
This button takes effect only on the slave MPUD.
If the indicator is on, you can remove the board.
If the indicator blinks once every two seconds (0.5 Hz), the system is in
the normal state. If the indicator blinks twice each second (2 Hz), the
system is in the alarm state.
If the indicator is steady on, the system is in the alarm state.
If the indicator is steady off, the system is in the normal state.
If the indicator is on, the MPUD is in the active state.
If the indicator is off, the MPUD is in the standby state.
The button is used for resetting the MPUD. Press the Reset button, and
you can reset the MPUD.
If the indicator is on, the CF is in position.
If the indicator is blinking, data is being read or written.
If the indicator is off, the CF is not in position or can be removed.
If the indicator is steady on, the link is normal.
If the indicator is off, the link is Down.
If the indicator is blinking, data is being transmitted.
If the indicator is off, no data is being transmitted.
describes the interfaces on the MPUD and their uses.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4 E8000E-X3 Chassis Overview
15. AUX interface
84