Srua Indicators - Huawei Eudemon8000E Series Manual

HUAWEI Eudemon8000E Firewall
Hardware Description
Table A-6 Description of the indicators of the PEM
Indicator
RUN
ALM
A.2.3 SRUA Indicators
Table A-7
Table A-7 Buttons and indicators on the panel of the SRUA
Indicator/
Button
OFL button
OFL indicator
(red)
RUN indicator
(green)
ALM indicator
(red)
ACT active/
standby indicator
(green)
Reset button
CF ACT indicator
(green)
Issue 01 (2012-11-07)
Color Description
Green Indicates normal power output. If the indicator is on, it
implies a normal output.
Red Power failure indicator. If the indicator is constantly on, it
indicates the following:
l The lightning protection link of the PEM failed.
l The PEM does not have input power.
lists the status and descriptions of SRUA indicators.
Description
To remove a board, you must hold the button for six seconds until the
OFL indicator turns on.
This button takes effect only on the slave SRUA.
If the indicator is on, you can remove the board.
If the indicator blinks once every two seconds (0.5 Hz), the system is in
the normal state.
If the indicator blinks twice each second (2 Hz), the system is in the
alarm state.
If the indicator is steady on, it indicates that the system is in the alarm
state.
If the indicator is steady off, it indicates that the system is in the normal
state.
If the indicator is steady on, it indicates that the SRUA is in the active
state.
If the indicator is off, it indicates that the SRUA is in the standby state.
If you press the Reset button, you can reset the main control unit on the
SRUA.
If the indicator is on, it indicates that the CF is in position.
If the indicator is blinking, it indicates that data is being read or written.
If the indicator is off, it indicates that the CF is not in position or can be
removed.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
A List of Indicators
144