Table of Contents
Advertisement
FusionDC1000B Prefabricated Modular Data Center
Quick Guide (2021, Saudi, ITC)
2.1 Installing a 13.5 kW Integrated Air Conditioner
Prerequisites
Four installation positions are reserved at the pre-fab. module. Select four
installation positions based on the site requirements.
Procedure
Step 1 Open the front panel of the device, loosen the two M8 nuts from the compressor
base, remove the two compressor fasteners, and tighten the two M8 bolts again,
as shown in the following figure.
Figure 2-1 Removing compressor fasteners
Step 2 Remove the covers of the connection box, air intake vent, and air exhaust vent
from the pre-fab. module.
Issue 01 (2021-01-11)
Copyright © Huawei Technologies Co., Ltd.
2
Installation Guide
2 Installation Guide
3
Advertisement
Table of Contents
