Filling The Water Tank; Set Iron Temperature; Spray Function - Silvercrest SDBK 2400 D3 Operating Instructions Manual

Hide thumbs Also See for SDBK 2400 D3:
Table of Contents

Advertisement

Available languages

Available languages

B&3(B'DPSIEJHOHLVHQB%ERRN 6HLWH  0LWWZRFK  -XOL   

7.1 Filling the water tank

DANGER!
~ Pull the mains plug out of the socket be-
fore you fill up the water tank 16.
• Use clean tap water without any addi-
tives (e.g. vinegar, limescale remover,
starch, perfume, softener).
• The integrated anti-limescale protection
reduces limescale deposits for average
water hardness, and thus extends the
service life of the device. If your tap wa-
ter is hard, use distilled water. Where
the water is moderately hard, mix dis-
tilled water and tap water at a ratio of
1:1.
1. Disconnect the mains plug from the wall
socket.
2. Set the steam flow rate controller 5 to
.
3. The switch 11 is in the top position
. Remove the steam iron from the
stand 12. The cable base 10 remains
in the stand.
4. Open the lid 2 (of the water tank) and
hold the device at an angle to fill it.
5. Use the measuring beaker 22 to pour in
water up to the mark 21 max, but at
least up to one quarter. Hold the steam
iron upright to check.
6. Close the lid 2 (of the water tank).
7. Place the steam iron on the stand 12
and set the steam flow rate controller 5
to the desired position.

7.2 Set iron temperature

NOTE:
• The steam iron must be connected to the
cable base in order to heat up.
1. Figure D: Set the desired temperature
using the temperature controller 19:
- MIN the device is not getting hot
÷
-
Temperature: up to approx.
110 °C
÷÷
-
Temperature: up to approx.
150 °C
÷÷÷
-
Temperature: up to approx.
210 °C
- MAX maximum temperature:
2. The temperature control lamp 14 is lit
for as long as the steam iron is heating.
It goes out when the set temperature has
been reached. You can then begin iron-
ing.

7.3 Spray function

Use the spray function in order to dampen
dry items of laundry. This option is available
irrespective of the set temperature. For this
purpose, the water tank 16 must be at least
one quarter full.
• Press the spray button 3
While doing so, hold the steam iron
over the item of laundry. Ensure that no
water sprays onto the ground.
repeatedly.
51
GB

Advertisement

Table of Contents
loading

This manual is also suitable for:

270055

Table of Contents