GE
D
5573152-100, R
IRECTION
Table 8-65
3.
Re-install the upper two Phillips screws into
the Monitor. Leave enough clearance to
slide the Monitor onto the Arm.
With the Monitor flat, slide the Monitor onto
the Arm Assembly and support the lower
portion of the Monitor while the installing
the two lower Phillips screws (1).
Tighten the upper Phillips screws (2). Make
sure the Monitor is level before tightening
the screws securely.
(LCD Cable to Monitor {3} shown, will be
installed in the next step. 19 inch Monitor
only.)
. 2
EV
Monitor installation - R5.x and later (Ergotron)
Steps
Chapter 8 Replacement procedures
LOGIQ E9 S
Corresponding Graphic
19 and 23 inch Monitor (19 inch shown)
23 inch shown
OLED Monitor mounting screws and holes
M
ERVICE
ANUAL
8 - 101