Bosch Rexroth Hagglunds DUc MS2 Installation & Maintenance Manual page 56

56/88 Hägglunds DUc Drive unit | Commissioning
Bosch Rexroth AB, Version 06.2020, RE 15326-WA
Filling
Use a fluid filling pump unit with a filter rating of β10 ≥ 75.
Cleanliness in barrels with new oil is not clean enough for the system and has to
be filtrated before filling up in to the system to avoid problems.
Dirty oil in the system!
Damage on the equipment!
▶ Only use the specific filling point in the Drive Unit to fill up the hydraulic
system, see Fig. 2, Fig. 3, Fig. 4 and Fig. 5
Always pump the fluid in through the female quick connection included in delivery.
The fluid filled into the system will be filtered through the drain filter. See Fig. 52.
The tank must be filled with oil to the nominal level before starting for the first
time, according to Table 19. Check the function of the level sensor and indication
on the level gauge during filling up of the tank.
Fig. 52: Oil filling
Leakage of hydraulic oil
Risk of personal injury
▶ Check the caution sign on the hydraulic fluid container and the warnings in
section 2.
▶ Avoid long contact between skin and hydraulic fluid.
▶ Remove any spilled oil from the floor, great risk to slip and fall.
NOTICE
WARNING
DD00098805