Certifications And Regulatory Notes; Eu-Declaration Of Conformity; Operating The Device In Countries Out Of The Eu; Export Restrictions - Bosch ConnectS2 User Manual

Connect S2 | Solar Frame | User Guide

13 Certifications and regulatory Notes

EU-Declaration of Conformity

Operating the device in countries out of the EU

The Connect Gateway carries the CE mark and is certified for operation in the European Union. For countries outside the
European Union validate that local legal regulation allows the operation of the Connect Gateway.

Export Restrictions

Due to legal regulations the device must not be exported into the following countries or regions: Cuba, Crimea, Iran,
North Korea, Syria, Turkey and Ukraine.

Federal Communications Commission (FCC) Notice

FCC has issued an EQUIPMENT AUTHORIZATION to Robert Bosch Manufacturing Solutions GmbH – Bosch Connected
Industry for Connect S and Connect L according to FCC rule parts 15 with the FCC ID: 2AOSY-CONNECT02
The manufacturer is not responsible for any changes or modifications not expressly approved by the party responsible for
compliance. Such modifications may void the FCC authorization to operate this equipment.
Note:
1. This device complies with Part 15 of the FCC rules. Operation is subject to the following conditions:
a) This device may not cause harmful interference.
b) This device must accept any interference received, including interference that may cause undesired operation.
2. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority
to operate the equipment.
FCC Radiation exposure statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should
be installed and operated with minimum distance 20 cm between the radiator and your body as well as kept minimum 20 cm
from radio antenna depending on the portable or Mobile status of this module usage.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
© Robert Bosch Manufacturing Solutions GmbH
Hereby, Robert Bosch Manufacturing Solutions GmbH – Bosch Connected Industry
declares that the radio equipment type Connect S2 is in compliance with Directive
2014/53/EU and the Solar Frame is in compliance with Directive 2001/95/EU.
The full text of the EU declaration of conformity is available at the following internet address:
http://eu-doc.bosch.com
Model search: ConnectS2
Model search: SolarFrame01
32 | 39
Bosch Connected Industry