Signal Inputs And Outputs - Sony DNW-A75 Maintenance Manual

1-8. Signal Inputs and Outputs

1-8. Signal Inputs and Outputs
Remote connectors
8 REMOTE PARALLEL I/O (50P)
9 VIDEO CONTROL
9 RS-232C
9 REMOTE1-OUT (9P)
9 REMOTE1-IN (9P)
9 CONTROL PANEL
Input connectors
1 VIDEO INPUT, REF.VIDEO
1 VIDEO INPUT, COMPOSITE
1 VIDEO INPUT, COMPONENT
3 SDI
4 AUDIO INPUT
5 TIME CODE IN
7 AUDIO INPUT (AES/EBU)
1-10
< Reduced drawing of rear panel >
1 2
4
* D-SUB 50P connector (Refer to Optional "Interface manual" for details.)
D-SUB 15P connector
for a TBC remote controller (BVR-50) connection
D-SUB 9P connector (RS-232C interface)
for ISR (Interactive Status Reporting)
D-SUB 9P connector (RS-422A interface)
Remote control
D-SUB 9P connector (RS-422A interface)
Remote control
D-SUB (mini) 29P connector
for an outside control panel connection
BNC x 2 in loop through connection
Outside reference video signal (Black burst or composite sync)
0.3 V p-p, 75 Z, sync negative
BNC x 2 in loop through connection
Analog composite video 1.0 V p-p, 75 Z, sync negative
BNC x 3 (1 set: Y, R-Y, and B-Y)
Analog component video
Y
R-Y/B-Y : 0.7 V p-p, 75 Z
BNC x 1 (active through out x 1)
Serial digital interface (270 Mbit/s), complies with SMPTE 259M & ITU-R BT.656
XLR 3-pin x 4 (1 set: CH1, CH2, CH3, and CH4)
Analog audio 4 channels
LOW OFF : _60 dBu, high impedance, balanced
HIGH OFF : +4 dBu (Standard), high impedance, balanced
HIGH ON : +4 dBm (Standard), 600 Z termination, balanced
XLR 3-pin x 1
Time code 0.5 to 18 V p-p, 10 kZ, balanced
BNC x 2 (1 set: CH1/2 and CH3/4)
Digital audio 4 channels
AES/EBU format, complies with AES-3id-1995
3 !/
5
7
6
8
9
: 1.0 V p-p, 75 Z, sync negative
DNW-A75/A75P