Setting The T/H Sensor Device Address; Setting The Ups2000G-A Device Address - Huawei ECC500 User Manual

ECC500
User Manual
Figure 4-22 Restoring factory settings

4.4.1 Setting the T/H Sensor Device Address

Procedure
Step 1 Operate the DIP switch on the T/H sensor to set the device address for the sensor.
Toggles 1 to 6 of the DIP switch specify the device address in binary mode. ON indicates 1,
and OFF indicates 0.
Table 4-3 Mapping between T/H sensor device addresses and DIP switch settings
Device Toggle
Address Switch 1
1 ON
2 OFF
3 ON
4 OFF
----End

4.4.2 Setting the UPS2000G-A Device Address

Context
UPS2000G-A V100R001 is used and equipped with an LCD screen, as shown in
Issue 03 (2020-01-06)
Table 4-3
Toggle Toggle
Switch 2 Switch 3
OFF OFF
ON OFF
ON OFF
OFF ON
Copyright © Huawei Technologies Co., Ltd.
shows an example of the switch settings.
Toggle Toggle
Switch 4 Switch 5
OFF OFF
OFF OFF
OFF OFF
OFF OFF
4 Installation and Commissioning
Toggle Toggle
Switch 6 Switch 7
OFF OFF
OFF OFF
OFF OFF
OFF OFF
Toggle
Switch 8
OFF
OFF
OFF
OFF
Figure 4-23.
44