Table of Contents
Advertisement
Cleaning and care
Stainless steel trough
Risk of damage by pointed ob-
jects.
The seal between the hob and the
worktop could suffer damage.
Do not use pointed objects for clean-
ing.
Damage caused by soiling.
Soiling, particularly salty food or li-
quid and olive oil, can cause damage
if left on the printed surfaces for a
long time.
Remove such soiling immediately.
Damage caused by incorrect
cleaning.
Stainless steel cleaning agents rub
off the printed symbols.
Do not use stainless steel cleaning
agents on printed symbols.
Clean stainless steel surfaces using a
solution of warm water and a little
washing-up liquid applied with a soft
sponge. Soften any stubborn soiling
beforehand. If necessary, the rough
side of a non-scouring sponge can
be used.
Finally, dry with a clean soft cloth.
32
Stainless steel frame/control
panel
Clean the frame and the control panel
with a solution of warm water and a
little washing-up liquid applied with a
soft sponge.
You can also use a ceramic and stain-
less steel cleaning agent. We recom-
mend also using a stainless steel condi-
tioning agent to help prevent resoiling
(see "Optional accessories).
Do not use ceramic and stainless
steel cleaner or stainless steel condi-
tioning agent on the printing.
This would rub the printing off.
These areas should be only cleaned
with a solution of warm water and a
little washing-up liquid applied with a
soft sponge.
Rotary controls
Clean the rotary control(s) using a
solution of warm water and a little
washing-up liquid applied with a soft
sponge. Soften any stubborn soiling
beforehand.
Dry the control(s) with a clean cloth.
Advertisement
Table of Contents
