Configuring The Ptz Auto Tracking Application - Sony REA-C1000 Operating Instructions Manual

When using the RTMP streaming function:
The same video as the output on HDMI OUT is
streamed to a streaming service via LAN cable. Set
[HDMI OUT1] or [HDMI OUT 2] in [Streaming
Output 1] on the [Codec] tab (page 23) according to
the connection destination of the output device.
2
Turn on the camera and peripheral devices.
Notes
• The settings of the remote camera to be
connected must be configured beforehand as
described in "Input/Output" (page 14).
• It is recommended that the focus, white balance,
and exposure of the remote camera be set to Auto
beforehand.
• The zoom function of the remote camera uses the
optical zoom range only.
• Use these settings as the defaults on remote
cameras that can set the pan/tilt speed type and
zoom speed type.
• Remote camera settings may be changed from the
unit while the application is running.
• For details about remote cameras that support the
PTZ Auto Tracking application, see "Supported
Cameras and Available Camera Functions"
(page 54).
• SRG-300H devices with some serial numbers may
not operate. For details, contact your distributor.
Configuring the PTZ Auto Tracking
application
1
Select [PTZ Auto Tracking] from
[Applications].
2
Click the [Setup] button.
The setup screen appears.
A preview of the image from the camera is
displayed on the screen. When [PTZ Auto Tracking]
is selected for [Camera 1] from [Applications], the
image from the camera connected to the HDMI IN 1
connector is displayed. When selected for
[Camera 2], the image from the camera connected to
the HDMI IN 2 connector is displayed.
Note
If the camera image is not displayed, there may be a
problem with the camera connection or settings.
Check the connection and settings again.
Camera PTZ (pan, tilt, zoom) operation
You can control the PTZ movement of the camera
on each of the following setup screens. The controls
are common to all screens, but PTZ operations may
be grayed out depending on the settings.
Pan and tilt control
3
Configure the following settings.
Tracking mode
Select the tracking mode used for automatic
tracking.
[Free Object Pan Tracking]: Track the person
moving to the left/right in front of the blackboard
or screen.
[Fixed Frame Pan Tracking]: Track the person
moving to the left/right in front of the blackboard
or screen while giving priority to keeping the
contents of the board within the field of view.
Distortion correction
If the screen movement does not stay level when
panning, due to the remote camera position, size of
the room, or other setup conditions, enable [Correct
for Distortion] so that the screen motion stays level.
Note
To apply the appropriate correction, set appropriate
values for the camera position setup in step 5.
4
When finished, click the [Next] button.
36
Zoom control