Mitsubishi Electric MELSEC Q Series Reference Manual page 527

Error code Error
E521
H
to
E524
H
E5D1
H
to Network module error
E5D5
H
E5E1
H
to
E5E9
H
Transient execution error (no
E5F0
baton passing on the target
H
station)
Specified station No.
E5F1
H
duplication error
E5F2
H
to
E5F7
H
EA00
H
to
EA04
H
Network module error
EA10
H
to
EA18
H
EAE0
H
to
EAE4
H
EAE5
CPU module error
H
CC-Link IE Controller
EAE6
Network-incompatible CPU
H
error
EAE7
H
EAF0
H
Network module error
to
EAF6
H
F000
H
Errors detected in the MELSECNET/H or MELSECNET/10 network system.
to
( Troubleshooting in the MELSECNET/H or MELSECNET/10 Network System Reference Manual)
FEFF
H
Error detail
The hardware has failed.
Transient transmission was
executed while the target
station did not perform baton
(or token) passing.
The station No. specified for
the transient transmission is
duplicated.
The hardware has failed.
Incorrect data have been set
in the CPU.
The CPU module is not
compatible with the CC-Link
IE Controller Network
module.
The hardware has failed.
CHAPTER 10 TROUBLESHOOTING
Corrective action
• Please consult your local Mitsubishi representative.
• Reconnect the target station to the network.
• Execute the dedicated instruction, interlocking with
Baton pass status (own station) (SB0047) and Baton
pass status of each station (SW00A0 to SW00A7).
• Check the Cause of baton pass interruption (SW0048)
at another station and restart baton (or token) passing
before executing the transient transmission.
• If the error persists even after taking the above action,
please consult your local Mitsubishi representative.
• Change the station No. of the normal station.
• Please consult your local Mitsubishi representative.
• Use a CPU module that is compatible with the CC-Link
IE Controller Network module. (
Section 2.3)
• If the error persists even after taking the above action,
please consult your local Mitsubishi representative.
• Please consult your local Mitsubishi representative.
10
Page 40,
525