J(P)/G(P).Req (Remote Run/Stop) - Mitsubishi Electric MELSEC Q Series Reference Manual

9.7

J(P)/G(P).REQ (Remote RUN/STOP)

This instruction is used to remotely run or stop a programmable controller on another station.
Internal device
Setting
(System, User)
data
Bit Word
(S1) —
(S2) —
(D1) —
(D2)
[Instruction symbol] [Execution condition]
J.REQ
JP.REQ
G.REQ
GP.REQ
(1) Setting data
Setting data
Jn
Un
(S1)
(S2)
(D1)
(D2)
*1 The local devices and file registers for each program cannot be used as devices in setting data.
374
Link direct device
File
J\
register
R, ZR
Bit
[Instruction format]
Start contact
Start contact
Start contact
Start contact
*1
Network number of the own station (1 to 239, 254)
254: The network specified in Valid module during other station access
Start I/O signal of the own station's CC-Link IE Controller Network module
(00 to FE : The higher two digits of the 3-digit I/O number)
H
Start device of the own station that will store the control data
( Page 375, Section 9.7 (2))
Start device of the own station that stores request data
( Page 375, Section 9.7 (2))
Start device of the own station that will store response data
( Page 375, Section 9.7 (2))
The own station's device that is turned on for one scan upon completion of the
instruction
(D2)+1 also turns ON if the instruction execution has failed.
Available devices
Intelligent
function
module device
Word
U\G
—
—
—
—
Jn
J.REQ
Jn
JP.REQ
Un
G.REQ
Un
GP.REQ
Description
Constant
Index
register Zn
K,H $
(S1) (S2) (D1) (D2)
(S1) (S2) (D1) (D2)
(S1) (S2) (D1) (D2)
(S1) (S2) (D1) (D2)
Data type
Binary 16 bits
Device name
Bit
Others