Retrofitting The Large-Surface Filter - Miele PG 8581 Operating Instructions Manual

Retrofitting the
large-surface
filter
AD water
connection for
30-1,000 kPa (UK:
100-1,000 kPa)
pressure -
pressure-
resistant
(optional)
DI water ring line
IMPORTANT
UK, Australia and New Zealand
For the UK, Australia and New Zealand a non-return check valve is
required between the tap and filter.
 Do NOT shorten or otherwise damage the inlet hoses (see
diagram).
See installation diagram supplied.
If the water contains a high level of insoluble components, a large-
surface filter can be installed between the stopcock and the water
inlet hose.
The large-surface filter is available from the Miele Customer Service
Department.
This machine can be optionally supplied for a pressurised system
operating between 30-1,000 kPa (UK: 100-1,000 kPa). If the water
pressure is below 200 kPa the water intake duration will be
automatically increased.
The pressure tested hose for AD water, coded green, has a ¾ inch

threaded union for connection to the onsite stopcock for AD water.
 If the machine is not going to be connected to demineralised
(DI) water, the DI water connection has to be deactivated by the
Miele Customer Service Department. The intake hose remains on
the back of the machine.
The machine can be connected to a ring line system for DI water. For
this purpose, it must be technically adapted and the controls reset by
the Miele Customer Service Department.
Please contact the Miele Customer Service Department for further
information.
Plumbing
137