Table of Contents
Advertisement
Other symptoms
Symptom
Sound is not output even when the
play key is pressed.
Recording is not possible.
Sound is distorted.
Noise is noticeable.
*1
TOC
: All minidiscs contain a Table of Contents (TOC) in addition to sound signals. The TOC is similar to the table of contents in a book and contains
information, such as track numbers, track length, and character information, that cannot be rewritten.
*2
UTOC
: In addition to the TOC, minidiscs also contain a special User's Table of Contents (UTOC) that contains track number, track length, and character
information, that can be rewritten.
Cause
÷ The cords are connected erroneously.
÷ No disc has been loaded.
÷ A non-recorded disc has been loaded.
÷ The disc is write-protected.
÷ An attempt is made to record digital signal from
a source while its digital copy has been prohib-
ited by SCMS.
÷ The recording level is too low (in case of analog
recording).
÷ A playback-only disc has been loaded.
÷ The disc does not have a recordable area.
÷The REC INPUT key is not set to the actual input
source.
÷ If the amplifier is connected to this unit through
a system control cord, the amplifier's input
selector is set to the MD input.
÷ The recording level has not been adjusted.
÷ A disc in which distorted sound has been re-
corded is played.
÷ An external noise is induced.
In case of difficulty
Remedy
÷ Connect the cords in accordance with "Sys-
tem connections".
÷ Load a disc.
÷ Load a prerecorded disc or playback-only disc.
÷ Change the position of the write protect tab to
the write position or use a recordable disc.
÷ Use analog recording.
÷ Adjust the recording level again.
÷ Use a recordable disc.
÷ Use another disc.
÷ Set it according to the actual input source.
÷ Set the amplifier's input selector to other
position than MD.
÷ Read "Adjust the recording level".
÷ Use another disc.
÷ Install the unit at a position apart from an
electric appliance or TV set.
DM-S500 (En)
51
6
$
yu
™
™
u
™¢
™
p
p
Advertisement
Table of Contents
