Table of Contents
Advertisement
36
en | Installing the Pendant Arm Wall, Corner, and Mast (Pole) Mounts
Figure 9.12: Attach Pendant to Arm
1
2
2a
2b Dome Connector
3
4
2.
3.
Caution!
If you feel any resistance when rotating the dome housing or when engaging the connector,
!
stop immediately and start over.
4.
Caution!
You must tighten the two mounting screws to a minimum torque of 10-12 N-m (90‑105 in.-lbs)
!
to ensure a proper seal between the arm and the housing.
2020-07 | 1.0 |
Tilt up.
Hook and drop.
Recessed Hinge Pin
Rotate down to engage dome connector.
Tighten the two (2) mounting screws to a minimum torque of 10-12 N-m (90-105 in.-lbs).
Drop the dome housing down slightly to engage the dome housing hook on the Pendant
Arm hinge pin, allowing the dome to rotate around the pin.
Rotate the dome housing down to a vertical position and gently push upward to engage
the connector on top of the dome housing.
Hold the Pendant housing in position while tightening the two (2) 5-mm Allen head
mounting screws on top of the housing to 10-12 N-m (90-105 in.-lbs).
Installation Manual (pendant)
AUTODOME inteox 7000i - 2MP (pendant)
a
b
Bosch Security Systems
Advertisement
Table of Contents
