Mounting; Mounting Of The Mounting Bracket - Panasonic SF2B Series Instruction Manual

2-4 Mounting

2-4-1 Mounting of the Mounting Bracket

● For selecting the appropriate mounting bracket matched to the installation
environment, the mounting bracket is not incorporated in this device. Please
purchase the optional mounting bracket to fit on the mounting environment.
● Do not apply the load such as forced bending to the cable of this device. Apply-
ing improper load could cause the wire breakage.
● The minimum bending radius of the cable is R6mm. Mount the device consider-
ing the cable bending radius.
<Reference>
● Mount the emitter and the receiver at the same level and parallel to each other. The effective aperture
angle of this device is ±5° or less for a sensing distance of 3m or more.
● Unless otherwise specified, the following mounting procedure is common for both emitter and receiver.
For the preparation of the mounting, prepare the mounting holes on the mounting surface by referring to
"6-3 Dimensions."
<When the standard mounting bracket (MS-SF2B-1) (optional) is used>
Configuration
The standard mounting bracket (MS-SF2B-1) (optional) configures as follows.
1. Fix the standard mounting bracket with two hexagon-socket head bolts [M3 (length: 5mm)].
The tightening torque should be 0.6N·m or less.
2. For side mounting, remove the B part.
20
Ramco Innovations | www.ramcoi.com | 800-328-6236 | nsales@ramcoi.com
Hexagon-socket head bolt
[M3 (length 5mm)]
B part
A part
Hexagon-socket head bolt
[M3 (length 5mm)]
This device
Hexagon-socket head bolt
[M3 (length 5mm)]
B part
© Panasonic Industrial Devices SUNX Co., Ltd. 2016