Table of Contents
Advertisement
1-4-4. Location and Function of Switches/
LEDs
AVM-6 board
1
2
3
4
5
6
7
8
1 S501: Mode set switch (8-poles DIP switch)
1
1
1
1
Factory settings : All "OFF" side
S501-1 : D1/D2 system select switch
This switch selects the system of the video signal.
D1 : 4 : 2 : 2 component serial digital video signal
D2 : 4fsc composite serial digital video signal
S501-2 : Audio group select switch
This switch selects the group number of the audio data
to be multiplexed.
In D1 mode
GP1 : Group 1
The DID in a signal is set to audio group 1. The
input analog audio signal is multiplexed as 1 CH
through 4 CH in an SDI signal. If audio data has
been already multiplexed into the input SDI signal,
the input analog audio signal is multiplexed after all
audio data are erased.
GP2 : Group 2
The DID in a signal is set to audio group 2.
The input analog audio signal is multiplexed as 5
CH through 8 CH in an SDI signal. If audio data has
been already multiplexed into the input SDI signal
and the DID of the audio data has been set to audio
group 1, an analog audio signal is multiplexed
immediately later than the audio data.
BKPF-105A/205/205R
BKPF-206A/206/206R
9
!/
Component side (A side)
In D2 mode
GP1 : Group 1
The DID in a signal is set to audio group 1. The input
analog audio signal is multiplexed as 1 CH through 4 CH
in an SDI signal. If audio data has been already
multiplexed into the input SDI signal, the input analog
audio signal is multiplexed after all audio data are
erased.
GP2 : Group 2
The DID in a signal is set to audio group 2. The input
analog audio signal is multiplexed as 5 CH through 8 CH
in an SDI signal. If audio data has been already multi-
plexed into the input SDI signal, the input analog audio
signal is multiplexed as 5 CH through 8 CH in an SDI
signal after the audio data are erased. For a 4fsc com-
posite serial digital video signal, only a maximum of
four-channel audio data is input.
S501-3 : Factory use only
Keep as the default setting.
S501-4 and S501-5 :
Inhibit switches of audio multiplexing
These switches are inhibit switches of audio multiplexing.
S501-4
OFF : Multiplexes 1/2 CH normally.
ON :
Inhibits multiplexing 1/2 CH.
S501-5
OFF : Multiplexes 3/4 CH normally.
ON :
Inhibits multiplexing 3/4 CH.
1-4. Information of BKPF-205
1-13(E)
Advertisement
Table of Contents
