OfficeServ 7200
TECHNICAL MANUAL
2) When replacing an MCP or LCP board, first, remove link cables connecting the MCP
board to the LCP board. Also, remove all cables connected to the board to be
replaced.
LINK1
LINK2
3) Pull the lever of the board and pull out the target board slowly.
4) Align the new board to the guardrails of the slot, and slide the new board into the slot.
Push the front panel lever of the MCP board until it is completely inserted into the
OfficeServ 7200 main board port.
LINK3
Figure 3.13 Removing Cable
Figure 3.14 Removing Board
Figure 3.15 Replacing to New Board
3.13
Table of Contents
Home Page
INSTALLATION
PART 3 SEPTEMBER 2005