OfficeServ 7400
TECHNICAL MANUAL
PART 10. ADDING BOARDS TO THE
SYSTEM
10.1 ADDING STATIONS AND TRUNKS
1) Power the OfficeServ 7400 OFF before adding a new board. Locate a suitable
empty card slot. Having located a suitable slot, insert the new card into the slot and
push firmly in the middle of both card ejectors on the card to ensure that it is fully
inserted into the back plane connector.
2) After the new cards are inserted, the system must be told to recognize the new
cards. This is done through the use of MMC 806 Card Pre-Install. Use this MMC for
each new card that is installed.
3) The new cards must be assigned directory numbers according to the system
numbering plan in MMC 724. The technician must know the software port
assignments of the new cards so the ports can be assigned correct numbers.
10.1
Table of Contents
Home Page
INSTALLATION
PART 10 JUNE 2006