Operation
4
Replacing the radio gateway
56 | 64
Building Technologies
Fire System
Only confirm with 'OK' once you have switched gateways.
1. Switch gateways by connecting the 3.5 mm jack cable to the new gateway.
2. Confirm the successful data transfer with 'OK'.
3. The new radio gateway automatically has the net ID of the old radio gateway.
4. Check whether the LED (H4) is flashing.
H4
Figure 27:
5. Overwrite the net ID of the new radio gateway with the net ID of the old radio
gateway on the type plate.
6. Wait until LED (H4) stops flashing. This can take 1...2 hours depending on the
complexity of the radio cell.
7. Install the new radio gateway at the location of the old radio gateway.
8. Establish a cable connection to the detector line.
9. Switch the detector line on.
10. Dispose of the old, unusable radio gateway according to regulations.
The replacement of the radio gateway is complete.
A6V10425605_b_en_--
2016-12-12