Table of Contents
Advertisement
Design-in Guide - Philips Xitanium LED Xtreme SR driver
How to Select an appropriate driver
Depending on application requirements, several drivers may fit a
specific application. The following steps will help in selecting
the appropriate driver(s). For a complete overview of the
available drivers, please refer to www.philips.com/technology.
1. Determine the required driver current (I
2. Calculate the required power (P
(W)
3. Select the datasheets from the website mentioned above based
on the driver having a higher power than required.
4. Does the required current fit the current range of the driver?
The current range of the driver can be seen in the name
itself. For example, for driver Xi SR 75W 0.2 – 0.7A SNEMP
S240 sXt, the minimum programmable driver current is 0.2 A
and maximum is 0.7 A.
5. Does the required voltage fit the voltage range of the driver?
The exact value can be found in in the datasheet.
6. Does the required power fit the power range of the driver? In
the naming of the driver, you can see the maximum possible
output power. For example, for driver Xi SR 150W SNEMP
S240 sXt, the maximum output power is 150W.
7. Choose the preferred dimming method. Please refer to the
section Driver naming to verify dimming options.
Programming the output current
The Xitanium LED Xtreme SR drivers offer an extensive range
of controls, enabling customizable luminaire design and performance.
It is possible to control light output levels, preset dimming
protocols and set system specifications in the factory and even in the
complete installations.
This can be done with the Philips MultiOne configurator. The
MultiOne configurator is an intuitive tool that unlocks the full
potential of all programmable drivers from Philips, ensuring that the
driver performance matches the needs of the lighting solution. It
offers unprecedented flexibility, before, during and after the product
installation.
Programming of new Xitanium LED Xtreme SR drivers can be done
either by using the SimpleSet or the SR interface.
For more information on MultiOne please refer to the section
Driver Configuration or visit: www.philips.com/multione. This site
contains detailed information on how to install the software and
how to program the driver.
) and voltage (V
)
drive
f
) where P
= V
x I
drive
drive
f
drive
16
Advertisement
Table of Contents
