Figure 54 Location Of Ports On A Poe Injector - Nokia FastMile Installation Manual

Mounting and connecting the Nokia FastMile 4G
Receiver
15
16
17
Figure 54
18
74
Pass the Ethernet cable from the Nokia FastMile 4G Receiver through the hole that was
drilled in the wall, and use silicone or other waterproof sealing or caulking compound to seal
the hole.
Do not run the Ethernet cable to the residential gateway or PoE injector yet.
Confirm that the residential gateway that is going to provide service for the Nokia FastMile
4G Receiver is installed and powered up, or install and power up the residential gateway.
A properly earthed wall socket should be used for powering the residential gateway.
If the Nokia FastMile 4G Receiver is not going to be powered from the residential gateway,
set up a Nokia-approved PoE injector that is going to provide power over Ethernet to the
Nokia FastMile 4G Receiver, including connecting the PoE injector to the residential gateway
at the PoE injector's "LAN" port and to power. A properly earthed wall socket should be used
for powering the PoE injector. Nokia advises that the PoE injector should be grounded and
put as close as possible to the place where the Ethernet cable enters the home.
Figure 54 shows the location of the "LAN" port on a PoE injector. Specifics of the set up will
depend on the PoE injector and residential gateway.
Location of ports on a PoE injector
Connect the Nokia FastMile 4G Receiver to the residential gateway or PoE injector:
3TG-00387-AADA-TCZZA
Nokia FastMile 4G Receiver Installation Guide
L A N
P O E
LAN port PoE port
27902
Issue: 02 DRAFT