Programmable Parameters; Measurement Types And Ranges - Siemens SIMATIC Manual

Analog modules
6.17 Analog IO module SM 334; AI 4/AO 2 x 12 bit; (6ES7334-0KE00-0AB0)
6.17.1

Programmable parameters

Introduction
For general information on programming analog modules, refer to the chapter Programming
analog modules (Page 294).
The table below provides an overview of configurable parameters, including defaults:
Table 6- 40 Summary of parameters SM 334; AI 4/AO 2 x 12 Bit
Parameters
Input
Measurement
•
Measurement type
•
Measuring range
Output
•
Output type
•
Output range
6.17.2

Measurement types and ranges

Introduction
You can configure the outputs for operation as voltage or current outputs, or disable these.
You can wire the outputs as voltage outputs, or disable these.
Program the outputs at the "measurement type" AND output type" parameters in
Input defaults
The "thermoelectric resistance (linear, 4-wire connection)" measurement type and "Pt 100
Klima" measuring range are set by default at the module. You can use these default settings
without having to program the SM 334; AI 4/AO 2 x12 Bit in
490
Range of values
disabled
V Voltage
R-4L Resistance
(4-wire connection)
RTD-4L Thermal resistance
(linear, 4-wire con-
nection)
0 V to 10 V
10000 Ω
Pt 100 Klima
disabled
Voltage
0 V to 10 V
Default Parameter type
RTD-4L
dynamic
Pt 100 Klima
V
dynamic
0 V to 10 V
Scope
Channel
Channel
STEP 7
STEP 7
.
S7-300 Module data
Manual, 06/2017, A5E00105505-AJ
.