Switching An Object On / Off - Siemens FT2010 Operation Manual

6.5 Switching an object on / off

Building Technologies
Fire Safety
Switching an object on / off
To avoid To avoid ↑ false alarms, you can switch off parts of a ↑
e.g., for the purpose of maintenance work. e.g., for the purpose of maintenance work.
When a part of the 'Site' is switched off, the LED 'ISOLATION When a part of the '
In which situations the pre-configured object should be switched off, depends on In which
the detectors used as well as on possible deceptive phenomena such as smoke, the detectors used as well as on possible deceptive phenomena such as smoke, the detectors used as well as on possible deceptive phenomena such as smoke,
dust, heat or vapour. dust, heat or vapour.
You can use the <'Section' 'OFF'> button to ↑ switch off a pre You can use the <'
the touch of a button. the touch of a button.
WARNING WARNING
System parts that have been switched off make it impossible to acquire and System parts that have been switched off make it impossible to acquire and System parts that have been switched off make it impossible to acquire and
process alarms or faults! process alarms or faults!
Fire may spread unhindered. Fire may spread unhindered.
● Deploy staff to monitor the Deploy staff to monitor the deactivated area.
● You must switch deactivated parts of the ' You must switch deactivated parts of the 'Site' back on as soon as possible.
If a deactivated ' If a deactivated 'Zone' is the only 'Zone' in a 'Section', the '
indicated as deactivated. indicated as deactivated.
↑ Switching off the ' Switching off the 'Section'
ϖ Before you may switch off the pre Before you may switch off the pre-configured object, you must release
operation by means of the ' operation by means of the 'Key switch'.
1. Turn the ' Turn the 'Key switch' into a horizontal position.
Operation is released.

2. Press <' Press <'Section' 'OFF'>.
 The pre The pre-configured object is isolated.
 LED ' LED 'ISOLATION' on.
Switching on the object Switching on the object
ϖ The object is isolated and the LED ' The object is isolated and the LED 'ISOLATION' is on.
1. Turn the ' Turn the 'Key switch' into a horizontal position.
Operation is released.

2. Press <' Press <'Section' 'OFF'>
 The pre The pre-configured object is switched on.
 LED ' LED 'ISOLATION' off.
Switching an object on / off Switching an object on / off
ISOLATION' is on.
configured object should be switched off, depends on
switch off a pre-configured object at
' back on as soon as possible.
configured object, you must release
Operation
'Site' in certain situations,
', the 'Section' is also
' is on.
009310_l_en_--
2018-08-29
6
23 | 40