Starting Up The C 60; Start-Up - Bosch C60 Manual

7.1.1 Setting up the network interface
7.1.2 Power up the C60
Bosch Motorsport

7 Starting up the C 60

7.1 Start-Up

Install the software required for C 60 operation.
– RaceCon for setup, configuration and calibration
– WinDarab for measurement data analysis
Set up the online connection to the C 60.
– 100 MBit Ethernet connection to the C 60
– All three Ethernet ports of C 60 are internally connected by a network switch
– All Ethernet ports have 'cable auto crossover' functionality
– Minimum wiring loom:
Life connector (red)
Pin
Pin 1+2+3
Pin 4+5
Pin 6
Pin 7
Pin 8
Pin 9
Pin 10
– The C 60 contains a DHCP server, network addresses can be assigned automatically to
the configuration PC.
– The IP address of C 60 is 10.10.0.205.
– Switch off the PC's firewall.
– Set up the PC's network interface as shown in the screenshots.
– The C 60.LEDs will illuminate
– The 'Link LED' at the PC's network adapter will illuminate
– If the LED is off, check the wiring harness
Description
12 V supply voltage
GND supply voltage
Ethernet Tx+
Ethernet Tx-
Ethernet Rx+
Ethernet Rx-
Ethernet Screen
Select
'Internet
Protocol
(TCP/IP)'
Click
'Properties'
Data_Logger_C_60_Manual
Starting up the C 60 | 7
Select 'Obtain
an IP address
automatically'
Click 'OK'
when done
21 / 100