Step 8: Set Jumpers And Install Option Pcbs Onto The Actu - Toshiba Strara CTX Series Installation And Maintenance Manual

4. Connect the green/green-yellow wire from the AMAU motherboard to the FG screw on the power
supply.
5. Plug the DC cable into the CN OUT connector.
6. Install the ABCS battery charger.
7. Plug in the reserve battery cable to the CN-BAT connector of the ABCS battery charger.
8. Plug in the AC power cord connector into the AC-IN plug.
9. Insert and tight the two screws in front of the power supply (see
10. Plug the BASE/EXP jumper plug into the appropriate BASE or EXP connector on the power
supply (see Figure

Step 8: Set Jumpers and Install Option PCBs onto the ACTU

Refer to Figure 2-17
1. On the ACTU PCB, set the battery jumper, "BATT," to the "On" position.
2. On the ACTU, make sure the Mu/A jumper plug is set to the A position (U.K).
3. On the ACTU PCB, set the BBMS jumper "ATTACHED BBMS," to the "NO" position.
If you are installing the AETS option PCB, before mounting the AETS, dress its green jumper
Note
wire under and behind the Ethernet port and out the top as shown in
screw just above the AETS, place the jumper wire ring over the hole and replace the screw to
hold the jumper wire ring in place.
4. Install needed option PCBs onto the ACTU (AETS, AMDS, BSIS, ARCS).
5. Position the option PCB in its respective area with the arrow pointing up.
6. Line up the option PCB connectors and plastic stand-offs with the connectors and stand-off holes
on the ACTU and snap securely into place.
7. Insert the SmartMedia card (gold contacts face left, notched corner faces forward and up) into the
SmartMedia slot on the ACTU.
8. Make sure that the power supply switch is Off.
9. Install the ACTU into the Base Cabinet (see following photos).
For more details about the jumpers and add-ons (subassemblies) for the ACTU, see
Note
on Page 2-20.
Strata CTX I&M September 2002
2-14).
with the following steps.
Strata CTX100 Installation
Figure 2-15).
Figure 2-17. Remove the
Table 2-2
2-17