Tilt Stand For Dkt + 2 Adms - Toshiba Strara CTX Series Installation And Maintenance Manual

Tilt Stand for DKT + 2 ADMs

Use Tilt Stand models "BTSA" for DKTs with one or two ADMs.
To attach a digital telephone with two ADMs to a Tilt Stand
1. Complete the steps under
2. Make sure bottom phone jack is plugged in.
3. Remove Tilt Stand from Tilt Stand Base (see
4. Place the spacers on the outer holes, as shown (see
5. Attach Tilt Stand to bottom of DKT with screws.
6. Reinstall the Tilt Stand Base: Fit the Tilt Stand Base over the Tilt Stand so that the "bottom pegs"
fit into the holder. Adjust Tilt Stand so that the "top pegs" fit into the top Tilt Stand Base holes. Do
this to both stands.
7. Pull up on the Tilt Stand Bases so that they open to the maximum angle (30 degrees). See
7-24.
8. Push in the Lock Release button to adjust the tilt angle (0, 10, 20 or 30 degrees) of each Tilt Stand.
(A)
Spacer
1 ADM
1 ADM
2 ADM
2 ADM
1 ADM
1 ADM
2 ADM
2 ADM
Figure 7-23 Attach Tilt Stands to DKT with Two ADMs
Strata CTX I&M September 2002
"To install DADMs" on Page
2 ADMs + 1 DKT
ADMs
DKT
DKT DKT
DKT
1 ADM
2 ADM
DKT
Put in three screws in the
positions marked "2ADM."
Insert a spacer beneath each stand as shown. Put in the
screw with the spacer first. Then insert the other two screws.
7-20.
Figure 7-22).
Figure 7-23).
DKT
DKT
1 ADM
2 ADM DKT
Put in three screws in the
positions marked "DKT."
Station Apparatus
Figure
(A)
Spacer
DKT
1 ADM
2 ADM
5609
7-25