Removing Housing Covers; Mounting The Cri Piezo Return Flow Module; Preparing Cover - Bosch 1 687 010 393 Original Instructions Manual

en 18 | 1 687 010 393 |
3.4.1

Removing housing covers

1. Switch off the EPS 200 at the master switch.
2. Unplug the mains connector from the socket.
3. Secure the mains connector against unintentional
re-connection.
4. Switch off the compressed air supply.
5. Remove the left housing cover (fig. 1). To do so,
remove the bolts and detach the housing cover. Re-
move the protective conductor connection.
Fig. 1: Removing left housing cover
6. Remove the right housing cover (fig. 2). To do so,
remove the bolts and detach the housing cover. Re-
move the protective conductor connection.
Fig. 2: Removing right housing cover
|
1 689 989 187 2016-12-20
3.4.2

Mounting the CRI Piezo return flow module

1. Open the protective cover.
2. Secure the CRI Piezo return flow module with two
hexagon socket head bolts M6 x 12 and washers to
the retaining bracket of the protective cover.
M6 x 12
Fig. 3: Mounting the CRI Piezo return flow module
3.4.3

Preparing cover

1. Close the protective cover.
2. Remove the two Torx screws M5 x 10.
Fig. 4: Removing Torx screws
M5 x 10
Robert Bosch GmbH