Canon imagePRESS Server F200 Installation And Service Manual page 49

R
EPLACING PARTS
T
O REMOVE BOARDS AND CABLES FROM THE MOTHERBOARD
1 Shut down and open the imagePRESS Server (see pages
To access the motherboard, you must remove the left side panel.
2 Remove all boards installed in slots on the motherboard.
Note the location of the slot where each board resides so that you can reinstall the board in the
same slot later.
3 Remove the following cables from the old motherboard:
First remove any plastic cable clamp(s) securing internal cables and tie-wraps.
N :
OTE
• Front panel fan cable
• Reset button cable
• Power button cable
• Speaker cable
• UIB cable
• Front panel USB port cables
• DVD drive cables:
– SATA data cable
– Power and data combination cable
• Hard disk drive cables:
– SATA data cable
– Power supply cable
• Motherboard power cable
• CPU power cable
For motherboard connector locations, see
33 and 35).
page 47.
49