Connecting The Pressure Senser Tube - Toro Multi Pro 1750 Installation Instructions Manual

Figure 102
1. Eductor supply hose 2 x 88 cm (3/4 x 34-11/16 inches)
4. Assemble the 90° barbed fitting of the eductor supply
hose into the bottom port of the eductor-shutoff valve
(Figure 101).
5. Secure the 90° barbed fitting to the port of the eductor
shutoff valve with a small retainer
6. Tighten the flange clamp that secures the barbed fitting
of the eductor supply hose to the flange of the eductor
(Figure 102).
Connecting the Pressure
Sense Tube
No Parts Required
Procedure
Insert the pressure sense tube into the tube connector at the
end section valve
(Figure 101).
Machines without the spray wand kit or electric hose-reel kit
48
19
(Figure 103
Figure 103
1. Tube connector
2. End cap (ported)
or Figure 104).
3. Pressure sense tube